V6 Conversion Components

Components for converting a 2.8L Ford Cologne V6 into a Sunbeam Alpine.

Transmission Mounts

I have multiple transmission mounts available.

Components for converting a 2.8L Ford Cologne V6 into a Sunbeam Alpine.

Transmission Mounts

I have multiple transmission mounts available.

The above pictured transmission Bracket is designed for the V6 Ford engine mated to a late model Mustang T5 (the four bolt pattern Bracket pictured is for the Manual 4 spd transmission Alpines.  Brackets for the Borg Warner (BW35) Automatic Alpines which have the three (3) bolt pattern are also available.
Pictured above is the Tranny bracket for the C3/C4 type Automatic Transmissions installed in the manual Alpines.’  Also available for the Automatic Alpines factory fitted with the BW35.
The Transmission Bracket pictured above is for installing a FORD A4LD Automatic transmission in an Alpine Factory “fitted” with a Borg Warner BW35 Automatic Transmission.  See the three bolt pattern in the bracket?  A very distinguishing characteristic of the Automatic Alpine.  The A4LD Bracket is also available for the Manual type Alpine.

Engine Mounts

My designed engine mounts consist of two top and two bottom pieces used with large support rubber biscuits (Anchor P/N 2424).   Readily over the counter at most Auto Parts Suppliers.

Engine Mount Brackets w/ rubber biscuits pictured: Above left for Left side of engine and Above right for Right side of engine.  Nuts and bolts are included.

Fuel Block Plate & Upper Gas Pedal Rod

The Cross link (above background) I designed is one piece pressed & threaded for the tie rod ends.

In an attempt to cut the cost of the conversion components and retain safety and durability, I designed a set of bolts & spacers to serve as replacements to the crosslink and cut cost by about $100.00.  A stock cross link is pictured with my special bolts & spacers.  I do recommend neoprene bushings be purchased during rebuild if the bolts and spacers are to be used. The package in the picture has Sunbeam Specialties bushings.

Alternator Bracket

This is a 2 piece Alternator Bracket with adjustment arm. (Slots for alignment during installation are built in). Bolts are included.

A/C Compressor Mount

A/C compressor mounting bracket with adjustment arm

Clutch Slave Cylinder Mount

Clutch slave cylinder mounting bracket designed to sit farther away from the headers, giving added protection to the rubber components.  Bolts are included.

Water Neck by OFY for the 4 bbl Intake

Ofy Water Neck on left is stock.  The one on the right is modified by DanR to turn the neck to the left side for better routing of water hose connections in conjunction with the radiator. See recommendations for the Radiator modifications.

Thermostat Housing

Modified to mate with the radiator.

Recommended Radiator Modification

Straight Back Headers

Price List

My price list as of December 1, 2018. Prices subject to change.

Components for converting a 2.8L Ford Cologne V6 into a Sunbeam Alpine.

Transmission Mounts

I have multiple transmission mounts available.